Serpent 601367 Aluminium 25T Throttle Lever for SRX8 Gen4  [SER601367]

Precision Throttle Lever for SRX8 Gen4

This RC throttle lever is crafted for the SRX8 Gen4 platform and carries the Serpent reference 601367. The component is machined from aluminium with a 25T profile to replace factory levers on SRX8 Gen4 kits, offering improved rigidity for competitive GP-style setups.

Fitting is appropriate for hobbyists comfortable with throttle linkages; the lever clamps to the existing throttle shaft and uses original fasteners. Verify alignment and travel during setup, make careful tweaks to eliminate any binding, and confirm both idle and full-throttle positions before use.

As part of tuning the SRX8 Gen4 throttle behaviour, swapping to an aluminium lever reduces deflection versus typical plastic parts, producing a more direct servo-to-carburettor linkage transfer. Use it alongside measured changes to lever length and servo arm selection to refine throttle response.

A straightforward, serviceable component intended to integrate with SRX8 Gen4 throttle systems on GP-style kits.