Serpent 601373 98mm DJC Driveshaft Set for SRX8GTE R GP - Track Optimised  [SER601373]

Price:
NZD$0.00
Brand:
Serpent
Model:
SER601373
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

DJC Driveshaft Precision Fit for SRX8GTE R GP

The Serpent 601373 98mm DJC driveshaft set is built to refine the drivetrain behaviour of the SRX8GTE R GP. Its measured length and joint geometry promote steadier torque transfer during aggressive cornering.

Reduced Vibration and Heat

The Double Joint Cardan design lowers unwanted vibration and helps distribute load more evenly, which can reduce heat buildup in drivetrain components during long runs.

Race-Grade Toughness

Produced from resilient materials, this driveshaft set copes with the demands of club and national level racing while keeping service intervals predictable.

Specifications

  • Length: 98mm
  • Compatibility: Serpent SRX8GTE R GP

Can I swap these onto older SRX8 variants?

Older SRX8 variants may require adapters or trimming; compare the 98mm length and mounting ends to your existing shafts before fitting.

Are DJC driveshafts serviceable?

Yes, inspect joint faces and cups, clean debris, and relubricate as needed. Regular checks prevent premature wear.

Will this affect handling balance?

By smoothing power delivery and cutting driveline lash, a properly fitted DJC shaft can make handling more predictable, especially midcorner.

What should I check after installation?

After fitting, verify free movement, check for binding at full steering lock, and recheck hardware torque after a short test run.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved