Serpent 601380 Throttle Servo Arm - Compatible with SRX8 Gen4 GP (SER600024)  [SER601380]

Serpent SER601380 Servo lever throttle
Price:
NZD$7.48
Brand:
Serpent
Model:
SER601380
Condition:
Brand New
Write a review

Replacement servo arm for precise throttle control

The Serpent 601380 servo lever throttle is supplied as a replacement-style arm for Serpent SRX8 Gen4 GP (SER600024) kits. It mounts between the servo spline and throttle linkage to give a reliable attachment point for setting servo throw.

Fitting only requires basic servo handling: remove the existing arm, set the new lever onto the spline at the chosen neutral, secure it with the retaining screw, then attach the linkage and check travel. Confirm transmitter endpoints and center before running the car.

In tuning the arm changes leverage and geometry for the throttle linkage, so small positional changes alter sensitivity and the total available travel. Make measured adjustments and inspect for any binding at full travel.

Which SRX8 Gen4 variants use this lever?

This item is listed for Serpent SRX8 Gen4 GP (SER600024). Check your chassis revision and parts list to ensure this lever is correct for your specific kit prior to purchase.

How should I set the neutral position during installation?

Set the transmitter and servo to neutral, fit the lever to the spline so the throttle linkage is at its neutral point, then tighten the retaining screw and verify neutral stays correct when powering up.

Could this lever increase servo load or binding?

If fitted incorrectly or positioned at an extreme, the lever can increase load or cause binding. Ensure the linkage geometry is free through the full stroke and that endpoints are correctly set.

Any setup tips for smoother throttle response?

Use incremental changes to lever position, match arm length to servo torque, and use transmitter exponential or endpoint adjustments to fine tune the initial response without risking full-travel binding.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved