Serpent 601382 Replacement Upright Inserts for SRX8 Gen4 GP (SER600024) [SER601382]

Serpent SER601382 Adjustable upright inserts

Price:

NZD$11.26

Brand:

Serpent

Model:

SER601382

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Adjust Upright Settings

This adjustable upright insert is made for micro-adjusting upright geometry on Serpent SRX8 Gen4 GP (SER600024) chassis. It allows you to change mounting points and tweak steering and suspension characteristics without swapping the entire upright.

The fitting process is familiar to anyone used to servicing spindles and uprights: remove the hub area, insert the tuning piece into the upright boss, then reassemble and check for full wheel clearance. Follow the chassis manual for correct fastener torque values and bearing positioning to prevent binding.

Use the insert as part of a methodical setup routine to adjust roll center, scrub radius and steering sensitivity in controlled increments. Combine on-track testing with small changes to identify the best configuration.

Will these inserts produce big handling jumps?

No, they are intended for incremental adjustments. Expect subtle shifts in roll behavior and steering feel that are best evaluated over several test runs.

What is the recommended fitting procedure?

Remove the wheel hub components, fit the insert into the upright boss, then reassemble using the chassis torque specs. Check clearance and bearing alignment before running.