Serpent 601395 Replacement Front Shocktower for SRX8T RTR SRX8 Truggy-E  [SER601395]

Replacement front shocktower for SRX8T RTR

The Serpent 601395 front shocktower is offered as a swap-in part for SRX8T RTR chassis. This description concentrates on fit accuracy, the shocktower's role in suspension geometry, and useful checks to perform during service or setup.

As stated in the product title, this component is intended for SRX8T RTR machines in the SRX8 Truggy-E RTR EP family. Confirm the chassis code on your car matches SRX8T RTR to ensure mounting points and shock alignment are correct.

The front shocktower locates the upper shock mounts and provides fixings for upper links and body supports. When replacing, make sure the shock eyelet spacing and arm pickup locations match your current assembly, and verify there is no interference with the servo, electronics, or steering link components.

To install: remove bodywork and shocks, support the suspension to protect springs and shock shafts, and use original hardware if it fits without play. Inspect contact surfaces for damage and set fastener torque consistently to preserve handling characteristics. Minor changes to hole choice or shimming will affect ride height and roll centre for fine tuning.

For events, pack spare screws and a small hex set, and check wheel alignment after reassembly. Because the tower affects steering response and front compliance, carry out a controlled run to validate behaviour before hard use.