Serpent 601398 RR Transmission Brace Compatible with SRX8 Gen4  [SER601398]

Strength and fitment for the SRX8 Gen4 rear transmission

The Serpent SER601398 transmission brace serves as an aftermarket replacement/upgrade tailored to the SRX8 Gen4 chassis for the RR mounting location. It is aimed at controlling flex in the rear transmission area to affect driveline stiffness and track manners while leaving motor and electronics unchanged.

What it does: provide a measurable change in flex at the rear transmission mount so you can tune balance and feel. This item is intended for SRX8 Gen4 designs; check that your chassis uses the RR mounting orientation to ensure correct fitment.

Fitting guidance: clean contact areas and use the existing hardware unless replacement fasteners are included. Install the brace and tighten incrementally, watching driveline alignment. Note that altering brace stiffness can change suspension feedback and traction, so proceed with stepwise testing.

Service tips: after sessions, check the brace and nearby mounts for wear or loosening. Track changes in lap times or handling when swapping bracing options, and maintain a setup log for reproducible adjustments.

Install the Serpent SER601398 brace on SRX8 Gen4 builds to increase rear transmission stability and sustain consistent performance across runs.