Serpent Medius X26 Bulkhead Stiffener Graphite - O-SPP004 by Factory Pro  [FP-O-SPP004]

Designed by Factory Pro for the Serpent Medius X26, this graphite bulkhead brace is an aftermarket stiffening plate for RC touring cars. It is intended to be mounted at the Medius X26 bulkhead to reduce unwanted flex during dynamic maneuvers.

The plate increases localized stiffness where the bulkhead meets the chassis. That alteration of flex behaviour helps maintain predictable balance between front and rear grip without modifying suspension geometry. It is useful for drivers seeking repeatable handling over longer runs.

Fitting the brace is a straightforward task for those used to Medius X26 maintenance: remove the body panels as required, undo the current bulkhead screws, lay the graphite brace in position and tighten with the original hex screws. Verify driveshaft and linkage clearances once fitted.

This brace is made specifically for the Serpent Medius X26 chassis; confirm your chassis code to prevent ordering errors. It is intended for scale RC use only and not for real vehicles.