Serpent Medius X26 Compatible Tensioner Shaft 402201  [SER402201]

Serpent SER402201 Belt tensioner shaft X26
Price:
NZD$195,341.15
Brand:
Serpent
Model:
SER402201
Condition:
Brand New
Write a review

Overview of the X26 tensioner shaft

The Serpent 402201 belt tensioner shaft is a steel replacement part intended for use in belt-driven Serpent Medius X26 kits. Its purpose is to set and preserve belt tension inside the tensioner unit so the belt runs true and slack-related drivetrain loss is minimised in electric on-road applications.

Targeted at hobbyists and workshop technicians, this shaft fills the tensioner pivot position in the chassis and works with the pulley and mount to maintain belt alignment under load. As an aftermarket component it focuses on mechanical strength and correct fit rather than cosmetic finish.

Installation guidance: place the shaft into the tensioner bracket and pulley assembly following your kit's build order, check pulley freedom and belt tracking, then verify tension over full travel. Treat this as a kit replacement part and consult your manual or vendor for any torque or small hardware details.

Specifications

  • Item: Belt tensioner shaft
  • Material: Steel
  • Model Number: 402201
  • Compatibility: Serpent Medius X26 (SER400052)

A straightforward steel swap for the Medius X26 tensioner, aimed at constructors and tuners who want reliable belt tension and drivetrain consistency in electric RC kit setups.

How do I confirm this fits my X26 kit?

Check the part reference against your kit's parts list. The shaft is listed for Serpent Medius X26 with compatibility reference SER400052; confirming against your kit drawings ensures correct fit.

Will I get any small hardware with the shaft?

The description indicates the shaft itself is supplied. For included screws, pins, or spacers check the product page or ask the seller, since those items may not be packaged with the shaft.

Best practice to avoid pulley wobble?

Ensure the shaft is fully seated and the pulley bearings are clean. Confirm the pulley stack is assembled square to the bracket and test belt run under suspension movement to detect any wobble.

Does this shaft change handling or tuning?

The part maintains belt tension reliability rather than altering chassis geometry. Consistent belt run can reduce driveline lash, which helps predictable throttle response during tuning sessions.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved