Serpent Medius X26 Graphite Rear Body Plate Replacement O-SPP010 by Factory Pro  [FP-O-SPP010]

Replacement rear body panel for Medius X26

This rear body plate is an aftermarket hop-up manufactured by Factory Pro specifically for the Serpent Medius X26 chassis. The part carries the Factory Pro O-SPP010 identifier and is finished in graphite to align with the vehicle's rear body mounting points.

The component functions as a direct replacement for the rear body mount and can act as a minor tuning item, where rear stiffness and weight distribution subtly influence handling. It is intended exclusively for hobby use on the Medius X26 chassis and should be mounted at the factory mounting points using the original hardware.

Installation on the Medius X26 follows a simple procedure: remove the old plate, inspect alignment of posts and holes, transfer original fasteners, and check body clearance around suspension and motor. Once installed, ensure the body is correctly seated and that it does not impede suspension travel or gearbox components.

Maintenance recommendations: check the graphite plate for cracks after impacts, keep mounting faces clean, and resecure fasteners after the initial run to make sure the part is correctly seated. This part is suitable for restoring rear body geometry after a crash.