Serpent Medius X26 Lower Suspension Arm Upgrade Graphite O-SPP007 for tuning by Factory Pro  [FP-O-SPP007]

Price:
NZD$47.45
Brand:
Factory Pro
Model:
FP-O-SPP007
Condition:
Brand New
Write a review

Replacement lower arms tailored to Medius X26

This Factory Pro replacement is an RC-scale lower suspension arm set intended for use on the Serpent Medius X26 chassis, supplied as one set per car. The parts are produced in graphite to offer a balance of stiffness and damping response appropriate for fine suspension tuning on 1/10 on-road models.

The arms act as direct-fit replacements for the factory items on Medius X26 layouts, and are intended to influence roll center and lateral stiffness when paired with your existing uprights, hinge pins, and hardware. Installation requires basic RC tools and a routine check of hinge-pin alignment, camber link geometry, and free travel to avoid binding.

For setup, use the graphite arms to explore changes in mid-corner grip and transient response; monitor wear at pivot points and replace or service hinge pins and bushings as needed. Always confirm clearance with steering and suspension travel before full-power runs.

Specifications

  • Item: Lower suspension arm set
  • Material: Graphite
  • Model Number: O-SPP007
  • Compatibility: Serpent Medius X26
  • Quantity: 1set/car
  • Brand: Factory Pro

Ideal for drivers wanting to tweak Medius X26 response; inspect fitment and maintain pivots after installation.

Are these arms robust enough for regular club use?

The graphite construction offers improved stiffness but check for impact damage after crashes; with normal use they hold up well if pivots and pins are kept maintained.

How should I inspect the arms for wear?

Look for cracks at mounting holes and measure play at the pivot points; replace if you detect deformation or excessive movement.

Do these change how often I service the suspension?

You may need to check pivots slightly more often since higher stiffness can transfer more load to pins and bushings; routine inspection is recommended.

Can I reuse my current hinge pins and bushings?

In most cases yes, but verify fit and straightness; replace worn pins or bushings to preserve suspension geometry and avoid binding.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved