Serpent SER110457 Thin 5x7x0.1 Shims 10 Pack  [SER110457]

Serpent SER110457 Shim 5x7x0.1 (10)
Price:
NZD$15.46
Brand:
Serpent
Model:
SER110457
Condition:
Brand New
Write a review

Micro Shims for Accurate Spacing

For model tuners who demand precise spacing, the Serpent SER110457 5x7x0.1mm shims provide a simple way to tweak clearances. These thin washers make small adjustments that can reduce unwanted play and improve component alignment.

Why Use These Slim Shims

The consistent 0.1mm thickness helps you make repeatable changes when setting gear mesh, bearing positions or link spacing. Because they are low profile, they correct fit without adding bulk that alters suspension geometry.

Versatile Applications

These 5x7 shims work with a range of RC parts and are handy to keep in your spares box for quick setup work. The pack quantity supports trial-and-error fitting so you can find the optimal stack for your model.

How should I measure shim thickness during setup?

Use calipers or a feeler gauge to verify the 0.1mm thickness before fitting, and note any stacked total when combining pieces.

Are these shims suitable for gear mesh tuning?

Yes, they are commonly used to fine tune pinion to spur clearance and help achieve consistent mesh without trial damage.

Do I need one or two shims for a single adjustment point?

It depends on the gap you need to close; many builders start with a single shim and add another if finer correction is required.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved