Serpent SER110459 4x6x1 Shim Set (10 Pieces) - Workshop Pack  [SER110459]

Serpent SER110459 Shim 4x6x1 (10)
Price:
NZD$26.94
Brand:
Serpent
Model:
SER110459
Condition:
Brand New
Write a review
alt="Serpent SER110459 Shim 4x6x1 (10)" title="Serpent SER110459 Shim 4x6x1 (10)"
alt="Serpent SER110459 Shim 4x6x1 (10)" title="Serpent SER110459 Shim 4x6x1 (10)"

Precision Spacers for Tuned RC Builds

Hobbyists seeking consistent handling will find the Serpent SER110459 4x6x1 shims handy for small clearance corrections. The set of ten metal spacers helps you dial in alignment between rotating parts and structural interfaces.

Where to Use These Spacers

These shims are suited for tasks such as trimming driveshaft endplay, setting gearbox lash and lining up suspension pivots. Their 4mm inner bore and 6mm outer diameter make them compatible with many common RC shafts and bearing types.

Best Practices for Fit and Longevity

Place shims carefully and recheck movement under load to prevent premature wear. Keep a few extras in your toolkit since small changes in stack height can noticeably affect handling and drivetrain life.

Can I use these shims on both front and rear assemblies?

Yes, they are general purpose spacers that can be used on any axle or gearbox location where the 4x6x1 size fits the shaft and bearing layout.

What material are the shims made from?

These shims are metal and intended for stable spacing under light to moderate loads; avoid using damaged shims in high stress areas.

How do I measure if I need a shim?

Measure endplay or lateral movement with calipers or feeler gauges and add a 1mm shim at a time until the desired clearance is obtained.

Is this pack enough for multiple cars?

A ten piece set covers several minor adjustments but keep extras if you work on multiple builds or expect to experiment often.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved