Serpent 120035 48P 80T Race Spur Gear  [SER120035]

Serpent SER120035 Spur Differential Gear 48P/80T
Price:
NZD$19.27
Brand:
Serpent
Model:
SER120035
Condition:
Brand New
Write a review

Tune Your Setup with Serpent 120035

The Serpent 120035 spur differential gear uses 48-pitch teeth and an 80-tooth count to deliver predictable power transfer and smooth meshing. Its precise tooth geometry helps reduce drivetrain lash and improves consistency lap after lap.

Built for Consistent Running

Made for racers who need a dependable component, this 48P 80T spur resists common wear patterns while maintaining clean engagement. The tooth count is chosen to give a middle ground between acceleration and top end, suiting mixed-condition tracks.

Wide Application Across Chassis

Serpent 120035 fits many models that specify 48-pitch gear systems, making it a straightforward swap when refreshing a drivetrain or testing alternate gearing for grip and top speed tradeoffs.

Can I use this gear on off-road buggies?

Yes, if the buggy uses 48-pitch spur gears. Check clearance with the chassis and slipper system before running.

Does the 48-pitch requirement affect pinion selection?

You must match a 48P pinion to keep correct mesh. Mixing pitches will lead to rapid wear or gear failure.

Is the Serpent 120035 good for tuning gearing steps?

Yes. The 80T size gives a useful baseline for stepping up or down tooth counts to fine tune acceleration and top speed balance.

What hazards should I watch for when fitting?

Ensure proper mesh and check for debris in the differential area. Incorrect mesh or foreign material can cause chipped teeth or binding.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved