Serpent 160137 Onroad Big Bore Shock Shafts - Circuit Tuners  [SER160137]

Serpent SER160137 Shock Onroad big Bore Shaft (2)
Price:
NZD$21.72
Brand:
Serpent
Model:
SER160137
Condition:
Brand New
Write a review

High Precision Shafts for Circuit Setups

Fit the Serpent 160137 Onroad Big Bore Shock Shafts to sharpen your car's response and maintain steady damping throughout laps. These shafts are tailored to onroad racing and help deliver repeatable performance.

Consistency Lap After Lap

The Serpent 160137 components are manufactured to precise tolerances to minimise play and wear, supporting stable rebound and compression characteristics. That consistency helps drivers fine tune setups with confidence.

Wide Compatibility for Onroad Builds

These shafts suit many big bore shock configurations commonly used on competitive onroad models, allowing simple installation and quick setup changes. They are a practical upgrade for racers and serious hobbyists alike.

Are Serpent 160137 shafts a direct swap for standard onroad shocks?

In many cases they are a drop-in replacement, but you should compare shaft length and diameter against your current parts to be sure.

Will these shafts change spring rates or just damping feel?

They mainly influence damping behaviour and seal performance rather than spring stiffness, so springs can remain unchanged while you adjust oil and pistons.

What checks should I do after installation?

Verify smooth shaft travel, no binding, and that seals seat correctly; recheck mounting hardware torque after a few runs.

Can I polish the shafts myself for better smoothness?

Light polishing can help, but be careful to preserve dimensions and finish uniformity; follow hobby shop guidance if unsure.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved