Serpent 302004 F190 Transmission Brace - Club Race Upgrade  [SER302004]

Serpent SER302004 Transmission holder brace FR F190
Price:
NZD$14.81
Brand:
Serpent
Model:
SER302004
Condition:
Brand New
Write a review

Tidy drivetrain support for the F190 with Serpent 302004

The Serpent 302004 Transmission Holder Brace is designed for the F190 range to strengthen the transmission area and reduce flex during cornering and acceleration. It acts as a solid support for the transmission assembly, promoting smoother power transfer and steadier performance on varied surfaces. The unit installs cleanly into the standard chassis layout for a hassle free upgrade.

Precision build to protect drivetrain parts

From Serpent's development line, this brace is constructed to stand up to repeated track use and to lower wear on bearings and gears by keeping alignment steady. The added rigidity helps drivers maintain control when accelerating out of tight corners.

Compatibility notes and installation tips

Specifically made to fit Serpent F190 EP (SER300030) and compatible models, the brace uses existing mounting points. Installation is straightforward; use hand tools and check gear mesh after fitting to ensure optimal engagement.

Older F190 variants with the same transmission footprint should accept the brace, though you may need to check screw lengths and clearances before finalising fitment.
By reducing transmission flex the brace can sharpen throttle response and give a more predictable rear end. It is a subtle change that benefits precise driving rather than drastically altering balance.
The brace typically installs with the standard hardware included in the vehicle or supplied with the part. Keep spare screws on hand in case lengths differ between chassis versions.
Inspect mounting screws for tightness and check surrounding components for signs of wear after sessions. Clean off dirt and debris to prevent abrasion and ensure long service life.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved