Serpent 302040 - M3x78 Trackrod for F190 EP Race Tuned Link  [SER302040]

Serpent SER302040 Trackrod M3x78
Price:
NZD$13.59
Brand:
Serpent
Model:
SER302040
Condition:
Brand New
Write a review

Serpent 302040 - M3x78 Trackrod Optimised for F190 EP

For modelers refining handling and consistency, the Serpent M3x78 trackrod is a useful upgrade. Tailored to the F190 EP platform, it improves steering accuracy and holds up well under regular track use. Precision tolerances help drivers feel smaller changes through the wheel.

Designed for Consistent Steering Feel

The M3x78 trackrod delivers a controlled blend of rigidity and slight flex, helping keep front-end behaviour predictable. That predictability aids in trimming toe and steering settings for improved lap times without adding instability.

Fitment with the F190 EP Chassis

Made specifically for the F190 EP (SER300030) chassis, this trackrod fits the intended mounting points and requires minimal setup changes. It is a tidy replacement that supports quick reassembly and setup checks.

Can I use this on older Serpent touring cars?

Compatibility varies by model. The M3x78 is intended for the F190 EP. Check thread pitch and overall length against the older car before fitting.

Is any special hardware needed for installation?

Installation generally uses standard screws and ball ends from the kit. Keep original hardware unless replacements are specified in your setup notes.

How do I check alignment after fitting?

After fitment, centre the servo and measure toe at the wheel hubs. Make small adjustments and test on a short run to confirm handling.

Does this affect steering sensitivity?

Yes, the trackrod can change steering feel slightly. Its precise length and stiffness help produce crisper response when combined with proper servo mapping and geometry.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved