Serpent 302053 F190 13T HTD Pinion Gear - Track Spec  [SER302053]

Serpent SER302053 HTD piff pinion 13T F190
Price:
NZD$31.99
Brand:
Serpent
Model:
SER302053
Condition:
Brand New
Write a review

Track-Focused 13T HTD Pinion for F190

The Serpent 302053 HTD Pinion Gear 13T is crafted for the F190 line to sharpen gear engagement and improve torque transfer. Its 13-tooth arrangement is chosen to balance acceleration and straight-line speed for circuit driving.

Durability and Control for Competition

Made to suit the F190 EP chassis, this pinion copes with repeated high-load starts while retaining consistent tooth profile integrity. The 13T option helps drivers tune their gearing to match motor rpm and track characteristics without sacrificing reliability.

Specifications

  • Tooth Count: 13T
  • Compatibility: F190 Series
  • Material: High-strength metal for durability

The Serpent 302053 HTD Pinion Gear 13T is a practical upgrade for F190 owners wanting repeatable performance and long service life in racing use.

Can I change top speed by swapping to this 13T pinion?

Yes, moving to a different pinion tooth count adjusts final drive ratio. A 13T will alter acceleration and higher speed depending on your spur gear and motor setup.

Is special lubrication required for this pinion?

Standard gearbox grease for metal gears is fine. Avoid over-greasing as excess can attract track debris and increase wear.

What should I check after first install?

Verify gear mesh, tighten grub screws to spec, and run a few short tests to confirm there is no binding or unusual noise before full sessions.

Will motor choice affect gear life?

High-torque motors increase load on the pinion; ensure the motor and ESC are tuned and that gearing matches the motor's power curve to avoid premature wear.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved