Serpent 400032 Project 4X PRO Precision 1/10 Touring Racer  [SER400032]

Track Brief for the Serpent 400032 Project 4X PRO

The Serpent 400032 Project 4X PRO is engineered to deliver predictable cornering and broad setup flexibility in 1/10 electric touring racing. Building on the 4X EVO lineage, it focuses on balance and fine tuning for a range of asphalt conditions.

Rear Geometry Tuned for Response

The redesigned rear suspension gives a stronger steering feel and a wider setup window that performs well on higher grip surfaces. This setup helps maintain rear stability while allowing drivers to push mid corner.

Horizontal Topdeck for Increased Bite

Adopting a horizontal topdeck increases steering bite and responsiveness. The 2mm carbon chassis has additional flex options and a keyed topdeck arrangement to reduce unwanted chassis change during running.

Controlled Damping for Balanced Handling

Compact roll dampers with through rod pistons remove membrane complexity and provide consistent balance. The larger heave damper with machined pistons enables precise rebound control to tune forward drive and traction.

Proven Development from a Specialist

Designed by David Ehrbar, the 4X PRO has collected ETS A final results and IFMAR-level placings, showing the model can perform at serious events when set up correctly.

If you want a touring car that responds to careful setup changes, the Serpent 400032 Project 4X PRO is a versatile platform for club to national level racing.