Serpent 401109 1/10 Rear Anti-roll Bar for S400/S411 Performance  [SER401109]

Serpent SER401109 Anti-roll bar Rear 1.6
Price:
NZD$0.00
Brand:
Serpent
Model:
SER401109
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Sharpen Rear Control with Serpent 401109

The Serpent 401109 rear anti-roll bar is a direct option for S400 and S411 owners seeking improved cornering precision. Its 1.6mm section focuses on stabilising the rear during mid to high speed turns for smoother lap consistency.

Measured Roll Stiffness for Track Use

This rear bar gives a clear change in chassis behaviour without drastic handling swings. At 1.6mm it tightens rear roll and assists with predictable weight transfer so drivers can push harder through complex sequences.

Simple Fit and Setup Workflow

Designed to drop into the Serpent S400 and S411 rear end, the piece uses factory mounting points for a clean fit. Install quickly trackside and then dial in small setup tweaks to match tyre choice and circuit conditions.

Is special hardware needed to install this bar?

No special parts are required. It mounts using the existing rear swaybar points on S400 and S411 chassis.

Will this make the car oversteer more?

A stiffer rear bar can increase oversteer sensitivity if the front is unchanged. Balance it with front settings or softer rear shocks to keep neutral handling.

How should I test changes after fitment?

Run a controlled few laps, then adjust one variable at a time: swaybar link position, shock rebound or rear toe to observe differences clearly.

Is the 1.6mm bar suitable for all track surfaces?

It works well on medium to high grip asphalt and carpet. On very low grip surfaces you may want a softer rear bar to maintain traction.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved