Serpent 401497 1/10 Rear Sway Bar - 1.4mm  [SER401497]

Serpent SER401497 Antirollbar 1.4mm Rear
Price:
NZD$9.55
Brand:
Serpent
Model:
SER401497
Condition:
Brand New
Write a review

Sharpen Handling with the Serpent 401497 Rear Sway Bar

For tuning enthusiasts the Serpent 401497 1.4mm Rear Anti-Roll Bar adds measurable reduction in body roll on 1/10 scale cars. It improves mid-corner stability so drivers can carry more speed through complex sections.

Setups for Low Grip and High Grip Tracks

The 1.4mm diameter gives predictable feedback when adjusting roll stiffness, letting you adapt from loose club surfaces to high grip race carpets. Use small incremental changes to find the sweet spot for each circuit.

Engineered for Regular Use

Built to withstand repeated tuning and weekend racing, the Serpent bar resists deformation and retains its shape under load. That durability helps keep handling consistent lap after lap.

Do I need special tools to install it?

Installation usually uses standard hex drivers and pliers. Basic tools are enough unless your chassis requires removal of other components for access.

Will this reduce oversteer or understeer?

Fitting a stiffer rear bar tends to reduce body roll and can increase rear grip in many setups, which may reduce oversteer but can also increase understeer if the front setup is not balanced.

How often should I check the bar?

Check the bar and link hardware after sessions or impacts. Look for wear at pivot points and ensure mounts are tight to prevent play that affects handling.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved