Serpent 401499 Performance 1.8mm Rear Antirollbar  [SER401499]

Serpent SER401499 Antirollbar 1.8mm Rear
Price:
NZD$9.55
Brand:
Serpent
Model:
SER401499
Condition:
Brand New
Write a review

Improve Rear Balance with Serpent 401499

For enthusiasts focused on precise chassis setup, this 1.8mm rear antirollbar helps dial in rear balance and predictable handling. The Serpent 401499 bar is a straightforward upgrade that tightens rear response without drastic changes to existing geometry.

Designed for Consistent Handling

The 1.8mm section adds stiffness to resist roll during cornering, which leads to steadier mid-corner behaviour and improved exit stability. It is a useful part for drivers chasing more consistent lap times and clearer feedback from the rear end.

Quick Fitment for Common Serpent Chassis

Engineered to suit Serpent mounting points, the antirollbar installs with basic workshop tools and standard hardware. Installation is fast, so you can focus on setup and track testing rather than extended bench work.

How do I confirm this fits my Serpent car?

Compare the part number to your chassis manual or consult your retailer. If in doubt, check mounting hole patterns and sway bar link locations for a match.

Will this bar affect corner entry or exit more?

The increased stiffness tends to reduce rear roll, which can improve mid-corner stability and exit traction. You may notice changes at both entry and exit, depending on overall setup.

Should I change shock settings after fitting this bar?

Small shock adjustments are often helpful to fine tune balance. Soften or firm the rear shocks incrementally to complement the bar's effect.

Is the 1.8mm thickness a big jump from stock?

Thickness impact depends on your current setup. For many cars the 1.8mm will be a noticeable step up in stiffness but still manageable with small tuning changes.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved