Serpent 401560 1/10 Suspension Brace for Tuners  [SER401560]

Serpent SER401560 Suspension Bracket 2 411-S
Price:
NZD$8.40
Brand:
Serpent
Model:
SER401560
Condition:
Brand New
Write a review

Fine-Tune Handling with Serpent 401560

The Serpent 401560 suspension bracket helps owners dial in their 1/10 scale RC setup for cleaner steering response and more consistent tracking. Its focus on accurate alignment reduces unpredictable movement when pushing corner speed.

Sturdy Build for Repeated Use

Produced from robust materials the Serpent bracket stands up to frequent running and routine impacts. The part is intended to maintain setup geometry over many sessions.

Broad Model Support

Compatible with a wide selection of 1/10 scale cars the bracket integrates with common suspension layouts and usually installs without major chassis alteration.

How often should I check the bracket?

Inspect mounting bolts and visible wear after every few sessions or after any hard crash to catch loosening or damage early.

Will it change the weight balance much?

Any bracket swaps add some weight but the Serpent 401560 is designed to be compact so changes to centre of gravity are minimal for most setups.

Is special hardware required?

It typically uses standard suspension fasteners, though you should confirm supplied hole sizes and use proper thread locker when recommended.

Can I use it on off-road cars?

While intended for many 1/10 scale platforms, check clearance and mounting points on off-road chassis before fitting to ensure compatibility.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved