Serpent 401633 Aluminium 19T Mid Pulley for S411 Performance Tuning  [SER401633]

Serpent SER401633 Pulley mid Aluminium 19T S411 4.0 (2)
Price:
NZD$52.79
Brand:
Serpent
Model:
SER401633
Condition:
Brand New
Write a review

Refine Your S411 Drivetrain with Serpent 401633 19T

The Serpent 401633 Aluminum 19T Mid Pulley is crafted to match the S411 chassis requirements, offering a solid aftermarket upgrade for precision tuning. Made from quality aluminium, it provides better resistance to wear while maintaining accurate tooth engagement for predictable power delivery on track.

Lightweight Strength for Lap Consistency

Using high-quality aluminium, this mid pulley keeps rotating mass low while remaining tough enough for regular club running. The result is improved throttle response and steadier performance over multiple heats without premature wear.

Simple Swap for Direct Fit

This 19T pulley is engineered to fit the Serpent S411 without alteration. Its exacting tolerances allow straightforward replacement of worn parts or a quick upgrade between race days, keeping setup time to a minimum.

Can I run this pulley on both carpet and asphalt tracks?

Yes, the Serpent 401633 is suitable for different on-road surfaces; its aluminium build helps maintain consistent engagement whether you race on carpet or paved circuits.

Is any additional balancing required after installation?

No special balancing is normally needed. Fit the pulley carefully and check for wobble; if the pulley runs true there is no need for extra balancing steps.

Will this reduce drivetrain noise?

A well-machined aluminium pulley can improve gear mesh consistency and may reduce irregular noise caused by worn plastic parts, but overall noise depends on the whole drivetrain condition.

Should I replace the pulley at regular intervals?

Inspect the pulley as part of routine maintenance; aluminium lasts longer than plastic but check teeth and shaft fit during regular service to catch any wear early.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved