Serpent 401647 Project 4X Carbon Front Brace  [SER401647]

Serpent SER401647 Stiffenerplate Front Carbon 4-X
Price:
NZD$19.28
Brand:
Serpent
Model:
SER401647
Condition:
Brand New
Write a review

Upgrade Chassis Response with the Serpent 401647 Carbon Plate

If you are tuning a Project 4X Touringcar, the Serpent 401647 Carbon Front Stiffener Plate is a practical upgrade to reduce flex and sharpen steering feel. Tailored for the Project 4X series, this carbon plate strengthens the front chassis area to deliver steadier handling during aggressive maneuvers without adding excess weight.

Main Benefits for Track Tuning

  • Material: High-grade carbon fiber provides stiffness and low mass for performance gains.
  • Compatibility: Specifically built to suit the Project 4X Touringcar EP 190mm chassis for an accurate fit.
  • Functionality: Increases overall front-end stiffness to improve steering precision and control.

Installation and Setup Guidance

Installing the Serpent 401647 is straightforward for modelers with basic tools. After fitting, recheck front-end geometry and make small tuning adjustments to dampers and toe to balance the new stiffness level for the best lap times.

Will this plate affect ride height or handling balance?

The plate itself is light and should not change ride height, but the added stiffness will alter handling balance so small setup tweaks may be needed.

Is special hardware required to fit it?

Installation normally uses the stock fasteners supplied with the chassis; check that thread engagement is correct and use thread locker if you race regularly.

Does carbon thickness matter for performance?

Yes, plate thickness affects stiffness. This Serpent 401647 is engineered to give a balance of stiffness and weight suitable for the Project 4X layout.

How often should I inspect the plate?

Inspect the plate and mounting points after every few sessions or after heavy impacts to catch any cracks or loose fasteners early.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved