Serpent 401648 Aluminum Midshaft Mount Project 4X Performance Part  [SER401648]

Serpent SER401648 Midshaft Mount Aluminium 4-X (2)
Price:
NZD$37.81
Brand:
Serpent
Model:
SER401648
Condition:
Brand New
Write a review

Stronger Midshaft Support for Precise Steering

Hobbyists tuning their touring rigs will appreciate the Serpent 401648 Aluminum Midshaft Mount crafted for the Project 4X platform. Produced from durable aluminum, it promotes accurate alignment and helps keep the centreline stable under stress.

Exact Fitment for Project 4X Platforms

Designed around the Project 4X layout, this midshaft mount tightens the centre section and limits unwanted flex. The firmer chassis feel helps maintain consistent handling across varied track surfaces and driving styles.

Why Aluminium Is Popular

Aluminium components are chosen for their strength to weight ratio and resistance to wear. The Serpent 401648 midshaft mount balances lower mass with robust performance, making it suitable for regular track use and tuning sessions.

Can I use this on modified Project 4X cars?

It is made to suit stock Project 4X mounting points. If your chassis has been altered, compare hole spacing and shaft alignment before fitting.

Will this part increase drivetrain wear?

When installed correctly, the aluminium mount reduces unwanted movement and can lower uneven wear. Keep driveline bearings clean and lubricated for best results.

Any rider tips for installation?

Use threadlocker where recommended, check shaft alignment after tightening, and perform a few short runs to confirm no binding in the driveline.

Is additional hardware required?

The mount uses the Project 4X factory mounting holes. Most builds will not need extra parts, but verify screw lengths and clearances on your specific setup.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved