Serpent 401651 Precision Aluminum Bearing Block Kit for 4-X  [SER401651]

Serpent SER401651 Bearingblock Front/Rear Aluminium Left + Right 4-X
Price:
NZD$100.35
Brand:
Serpent
Model:
SER401651
Condition:
Brand New
Write a review

Aluminum Mounts Optimised for the 4-X Chassis

Install Serpent 401651 aluminum bearing blocks to tighten up your 4-X chassis mounting points. These machined parts are intended for both front and rear use and keep bearings seated accurately under race loads.

Sharper Steering Response

By holding bearings more securely, the 401651 set reduces slop in the suspension pivots, translating to clearer feedback through the wheel and more predictable cornering on carpet and asphalt tracks.

Simple Fitment for Maintenance and Upgrades

The geometry matches Serpent 4-X attachment points so swap-over is straightforward when refreshing worn components or moving to an all-metal setup for improved repeatability.

Do these blocks add much weight to the car?

They add some mass compared with plastic, but the aluminum used is light and the gains in rigidity usually outweigh the small weight increase.

Can I use the same screws from the stock parts?

In many cases the original hardware fits, but inspect screw length and use the correct grade of bolt to avoid stripping or binding.

Will these blocks change suspension geometry?

They are designed to retain the factory geometry when fitted correctly, though minor setup tweaks may be needed to fine tune handling.

How do I care for aluminum blocks?

Keep mounting surfaces clean, check fastener torque regularly, and inspect for wear after heavy impacts to maintain performance.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved