Serpent 401656 4-X Wishbone Lower Set Front/Rear [SER401656]

Serpent SER401656 Wishbone Lower Front/Rear 4-X (2)

Price:

NZD$15.58

Brand:

Serpent

Model:

SER401656

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Tune Your 4-X Chassis with Serpent 401656 Wishbones

The Serpent 401656 lower wishbone pair is made for the 4-X chassis and brings increased strength and repeatable suspension geometry. Suitable for fitting at both the front and rear, these wishbones help deliver steadier cornering and consistent setup feel.

Why Choose These Wishbones

Compatibility: Specifically matched to the Serpent 4-X mounting pattern for straightforward replacement.
Durability: Built to stand up to frequent roadholding and club racing demands.
Precision Fit: Keeps suspension angles consistent to aid setup tuning and handling balance.

Can I swap these into older 4-X versions?

Most 4-X variants share the same lower wishbone mounting, but check hole spacing and clearance before swapping into older cars.

Are any setup changes needed after fitting?

You may need minor toe or camber adjustments to restore factory geometry, so recheck alignment after installation.

What maintenance keeps them lasting longer?

Regular inspection for cracks and keeping pivot points clean and lubricated will extend service life and preserve handling consistency.

Do they change handling feel significantly?

They provide firmer geometry under load which can make steering more predictable; changes are subtle but beneficial for setup control.