Serpent 401670 Precision Aluminum Heave Damper Clamps  [SER401670]

Serpent SER401670 Heave Damper Clamp Aluminium (2)
Price:
NZD$27.15
Brand:
Serpent
Model:
SER401670
Condition:
Brand New
Write a review

Refine Damper Response with Serpent 401670 Clamps

For hobbyists focused on suspension nuance, the Serpent 401670 Aluminum Heave Damper Clamp Set delivers a clean, stiff mounting point for your heave damper. Constructed from quality aluminium, these clamps help maintain consistent damper behaviour under load. They are a smart upgrade for track setups and technical driving.

Engineered Fit for Consistent Performance

The Serpent 401670 clamps slot into many popular RC chassis layouts, reducing unwanted movement and improving feedback through corners. Aluminium offers a favourable strength to weight ratio that helps keep unsprung mass down while improving durability in demanding conditions.

Installation Advice for Best Results

Fitting the Serpent 401670 is a simple workshop task for most builders. Make sure mounting faces are clean and compatible bushings or shims are used where required to maintain alignment. Routine checks will prevent loosening and extend the clamps life.

Do these clamps work with non Serpent chassis?

They can fit other chassis if the mounting geometry matches. Measure your damper post spacing and compare to the clamp profile before fitting.

Are there torque settings to follow?

Use moderate torque that secures the clamp without crushing aluminium; hand tighten then a small fraction more with a driver, checking for any movement under load.

Can I polish or coat the clamps?

Polishing or light anodising is fine if done correctly, but avoid removing too much material which could affect fit or strength.

Will these change ride height?

They are designed to preserve existing geometry; any change in ride height would come from altered shimming or damper position rather than the clamp itself.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved