Serpent 401685 Aluminium Centre Suspension Bracket for Project 4X  [SER401685]

Serpent SER401685 Central Suspension Bracket Front/Rear Aluminium 4-X
Price:
NZD$56.65
Brand:
Serpent
Model:
SER401685
Condition:
Brand New
Write a review

High-Precision Centre Suspension Mount

RC tuners aiming for tighter lap times will find the Serpent 401685 Aluminum Central Suspension Bracket a useful upgrade for the Project 4X Touringcar. Built from durable aluminium, it reduces unwanted chassis flex and keeps suspension geometry consistent.

How It Helps Your Setup

Designed with accurate dimensions for the Project 4X platform, the Serpent 401685 provides a rigid anchor point that improves cornering stability and feedback through the steering. The bracket's strength supports aggressive driving without compromising control.

Compatibility and Installation Advice

Specifically made for the Project 4X Touringcar EP 190mm, this bracket fits both front and rear mounting locations so you can experiment with balance and roll centre adjustments. Installation uses normal RC tools; take care to torque fasteners evenly.

The bracket is tailored to the Project 4X Touringcar EP 190mm. While dimensions are specific, some users have adapted it to similar chassis with custom mounting; measure carefully before attempting mods.
Aluminium is low maintenance but check for stripped threads and clean mounting faces during routine service. A light use of thread locker on steel bolts helps prevent loosening under load.
When adding a stiffer central bracket, you may want to soften springs slightly or alter damper settings to retain desired grip. Test one change at a time to find the right balance.
Most hobbyists can fit the bracket themselves using basic RC tools. If you are unsure about setup tuning, consult an experienced club mechanic for initial adjustments.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved