Serpent 401718 Carbon Servo Mount Plate Right Side for 4-X Touring  [SER401718]

Serpent SER401718 Servo Mount Plate Right Carbon 4-X
Price:
NZD$20.39
Brand:
Serpent
Model:
SER401718
Condition:
Brand New
Write a review

Improve Steering Control with Serpent 401718 Carbon Mount

The Serpent 401718 Carbon Servo Mount Plate is cut to match the 4-X Touringcar EP 190mm chassis layout. Positioned on the right side, this carbon fibre plate increases chassis rigidity and helps maintain clean steering lines during fast laps. Its low mass and solid construction suit drivers looking for consistent handling in race conditions.

Why Choose Carbon Fibre for Your Servo Mount

Carbon fibre combines light weight with high stiffness, which helps reduce unwanted movement in the steering stack. Fitting a carbon servo mount can make the car feel more responsive and reduce steering inconsistencies caused by flex.

Installation and Upkeep Guidance

When fitting the Serpent 401718 Carbon Servo Mount Plate, ensure bolts are torqued evenly and rechecked after practice sessions. Periodic inspections for loose hardware or surface damage will keep the mount performing reliably.

Can I use this on a different touring car?

This component is intended for the 4-X Touringcar EP 190mm. It might be possible to fit it to other cars with a similar servo position, but check the hole pattern and clearances first.

Will it change the car balance?

Because the plate is lightweight, its main effect is increased steering stiffness rather than a significant shift in overall balance.

Should I use threadlocker on the screws?

Many racers choose a medium strength threadlocker on metal-to-metal screws to keep the mount secure, but follow your usual maintenance practice and avoid over-tightening.

How do I spot carbon damage?

Look for cracks, fraying at the edges, or any separation in the layers. If the plate shows delamination or deep cracks, replace it to avoid failure on track.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved