Serpent SER401751 Pivotpin Holder 4X EVO Replacement Pack (8)  [SER401751]

Serpent SER401751 Pivotpin Holder up 4X EVO(8)
Price:
NZD$10.77
Brand:
Serpent
Model:
SER401751
Condition:
Brand New
Write a review

Keep Your 4X EVO Suspension True

The Serpent SER401751 Pivotpin Holder is a practical spare part for 4X EVO owners who want dependable suspension performance. It holds the pivot pins firmly to limit unwanted movement and maintain handling consistency.

Where It Fits and Why It Matters

Made for the 4X EVO series, the Serpent SER401751 matches the suspension layout to avoid changes in geometry. Correct fitment reduces uneven wear and helps maintain cornering balance at practice sessions or club events.

Fitting Tips for Minimal Downtime

Replacing the pivotpin holder is a quick maintenance job that gets cars back on the circuit with little fuss. Ensure pins and bores are clean and check the fit after a few laps to confirm everything sits correctly.

Can I use these on vintage 4X models?

They are intended for the 4X EVO line. Older 4X variants may differ slightly, so compare dimensions before fitting to avoid issues.

What signs indicate a worn holder?

Look for lateral play at the hub or visible deformation around the pivot bore. If steering feels vague, inspect the pivotpin holders first.

Should I clean parts before installing?

Yes. Remove dirt and old grease, then dry surfaces to ensure a snug fit and prevent premature wear on mating parts.

Are these compatible with aluminium uprights?

They work with typical upright materials, but check tolerance and clearances when using different alloys or aftermarket uprights to ensure proper fit.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved