Serpent SER401764 Red Shock Springs C=6.3 Performance Pair for 4X EVO (2pcs)  [SER401764]

Serpent SER401764 Shock Spring red C=6.3 4X EVO (2)
Price:
NZD$12.62
Brand:
Serpent
Model:
SER401764
Condition:
Brand New
Write a review

Dial In Suspension with Serpent SER401764

RC tuners looking for dependable spring rates will find the Serpent SER401764 Red Shock Springs useful for the 4X EVO. The fixed C=6.3 rate helps preserve consistent rebound and compression under load.

What They Do for Your Car

These springs enhance on-centre feel and steady the chassis during quick direction changes. They suit track layouts where consistent feedback matters and are straightforward to integrate with stock 4X EVO shock assemblies.

Installation and Upkeep

Before fitting, clean shock internals and inspect seals. Seat the spring evenly and cycle the shock to confirm smooth travel. Regularly verify spring free length and swap them out if performance drifts after hard use.

Are these springs compatible with other shocks?

They are intended for the 4X EVO shock geometry. Other shocks may accept the springs but check internal spring perch position and overall length first.

Can I tune handling with spacers and different collars?

Yes. Using different spring collars or spacers will change preload and ride height, allowing you to fine tune balance without changing the spring rate.

What maintenance keeps them performing?

Keep shocks clean, lubricated, and check for rust or pitting. Replace springs showing uneven coil spacing or reduced free length to maintain consistent handling.

Do these springs change ride height significantly?

Ride height can shift slightly with different preload settings. Use the same perch settings when comparing setups to isolate the spring rate effect.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved