Serpent SER401770 4X EVO 20.5mm Pullrod Kit (4 Pack)  [SER401770]

Serpent SER401770 Pullrod 20.5mm 4X EVO (4)
Price:
NZD$9.53
Brand:
Serpent
Model:
SER401770
Condition:
Brand New
Write a review

Serpent SER401770 Pullrod for 4X EVO Setup

The Serpent SER401770 is a four piece pullrod set cut to 20.5mm and built to suit the 4X EVO chassis. It provides spare parts for tuning roll centre and maintaining consistent suspension geometry.

Fitment Guide

This pullrod matches the mounting layout on 4X EVO frames, delivering correct length and alignment. If you are fitting to a different chassis, measure critical points to confirm compatibility.

Quick Install Notes

Ensure ball ends and screws are tightened without over torqueing to avoid thread damage. Periodic checks after a session will help you spot wear or loosening before it affects lap times.

Will these pullrods change the handling much?

Using a defined 20.5mm length gives predictable changes to roll characteristics. Small adjustments in length or ball position help refine handling without drastic changes.

What tools do I need to fit the SER401770?

A set of hex drivers, a small spanner for ball ends and thread locker for steel screws are all you need for a secure installation.

Are these pullrods prone to bending?

Under normal running they are robust, but severe impacts can bend them. Inspect straightness and replace any that show deformation.

Can I use them for setup experiments?

Yes, having a spare four pack makes it easy to try small changes to roll centre and antiroll without losing original parts.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved