Serpent SER401772 36mm Pullrods for 4X EVO - Pack of 4  [SER401772]

Serpent SER401772 Pullrod 36mm 4X EVO (4)
Price:
NZD$13.00
Brand:
Serpent
Model:
SER401772
Condition:
Brand New
Write a review

How to Use the Serpent 36mm Pullrod

The Serpent SER401772 Pullrod 36mm 4X EVO is a simple yet effective suspension link that helps you tune small handling traits. It suits model builders who want consistent link geometry without excess complexity.

Compatibility and Handling Effects

This 36mm length provides predictable leverage across a variety of setups and helps stabilise steering inputs. It works well in combinations where precise suspension behaviour matters, letting you dial in smoother cornering and better feedback.

Tips for Installation and Longevity

Fit the pullrod so there is no free play at either end and use thread locking where appropriate to prevent loosening. Inspect ball sockets and replace the rod if you notice bending or wear to keep handling consistent.

Can I use the SER401772 on vintage kits?

Older kits may accept the 36mm link but check mount spacing and required angles. Some vintage layouts need adapters or different ball ends for a proper fit.

Is there a recommended replacement interval?

There is no fixed timeline; check the Serpent SER401772 after intense use or crashes and replace if you observe deformation or excessive play.

Will this pullrod affect toe or camber?

Link length and mounting angle can influence dynamic toe and camber. Use measured changes to predict handling shifts rather than guessing adjustments.

What other Serpent parts pair well with this rod?

Matching Serpent ball ends and compatible suspension mounts ensures the cleanest fit and reduces the need for shims or modifications.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved