Serpent SER401799 Rocker Precision 4X PRO Part  [SER401799]

Serpent SER401799 Rocker 4X PRO
Price:
NZD$84.23
Brand:
Serpent
Model:
SER401799
Condition:
Brand New
Write a review

Upgrade Your Project 4X PRO EP Chassis with Serpent SER401799 Rocker

The Serpent SER401799 Rocker 4X PRO is ideal for pilots wanting better control and longevity from their Project 4X PRO EP setup. Designed to complement the original chassis layout, it supports better handling under load.

Why Fit the SER401799 Rocker

This rocker improves roll control and gives more consistent steering feedback, which helps when refining setup at club meetings or race days. It fits the Project 4X PRO EP design so you can swap parts without reshaping components.

Quick Fit Guide

Mounting the Serpent SER401799 Rocker takes basic tools and common RC know how. Check that fasteners are snug and that pivot movement is free. Periodic inspections will catch wear early and keep the unit performing.

Is the SER401799 only for the Project 4X PRO EP?

The SER401799 is produced to match the Project 4X PRO EP series. While it may physically fit some similar layouts, it is optimised for the Project 4X PRO EP chassis geometry.

How should I inspect the rocker after running?

After sessions, wipe away dust, check pivots for play and ensure screws remain tight. Replace any pins or hardware that show visible wear to avoid handling issues.

Can I adjust geometry after installing the rocker?

Yes, install the SER401799 then fine tune arm angles, shock positioning and anti squat to dial in grip and balance for different surfaces.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved