Serpent SER401834 Shockbody Spare Part  [SER401834]

Serpent SER401834 Shockbody
Price:
NZD$37.52
Brand:
Serpent
Model:
SER401834
Condition:
Brand New
Write a review

Refit Your Medius X20 MID with the Serpent SER401834 Shockbody

The Serpent SER401834 Shockbody is produced to exacting standards for the Medius X20 MID 1/10 EP series. It helps retain original suspension geometry and consistent handling across varied track surfaces.

Which Models It Matches

This shockbody is intended for use with the Medius X20 MID family and lists compatibility with parts such as SER400033 and SER400034. It serves as a direct swap to simplify upkeep of your shocks.

Tuning Tips and Best Practice

When fitting the Serpent SER401834 Shockbody, pair it with suitable springs and oil for your conditions. Careful setup and air-free bleeding will enhance damping control and front to rear balance.

Can I use this shockbody on custom shock builds?

You can adapt it for custom assemblies if the dimensions match. Verify shaft length and end cap compatibility before modifying your shocks.

Does the material require any special care?

Normal cleaning and inspection are enough. Keep the Serpent SER401834 Shockbody free of grit and replace O rings as needed to maintain sealing performance.

Will changes to oil affect handling a lot?

Yes, oil viscosity changes damping characteristics. Use small incremental changes to dial in rebound and compression while using the SER401834 as your baseline shock housing.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved