Serpent SER401836 Shock Shaft - Track Replacement  [SER401836]

Serpent SER401836 Shock shaft
Price:
NZD$25.26
Brand:
Serpent
Model:
SER401836
Condition:
Brand New
Write a review

Serpent SER401836 Replacement for Medius X20 MID Dampers

The Serpent SER401836 shock shaft is a necessary spare for Medius X20 MID 1/10 EP vehicles. Built to precise standards, it helps preserve consistent shock travel and predictable handling on different surfaces.

Which Medius Models Fit

This shaft is compatible with the Medius X20 MID series, including model numbers SER400033 and SER400034. It slots into the original shock assembly without modification when matched to the correct hardware.

Fitting Pointers

When installing Serpent SER401836, wipe all mating parts clean and replace any worn o-rings. Light lubrication on the shaft will smooth operation and limit premature wear.

Do I need new seals when replacing the shaft?

It is good practice to check and replace seals or o-rings when servicing shocks to ensure a tight fit and prevent leaks after installing the Serpent SER401836.

Will this change the car balance?

The shaft itself preserves stock geometry; overall balance depends on spring rates and oil choices, so pair the shaft with the correct shock setup for your track.

Can I straighten a bent shaft?

A bent shaft can cause binding and inconsistent damping. For safe operation, replace a bent Serpent SER401836 rather than attempting to reshape it.

What cleaning method is best before install?

Use a lint-free cloth and a mild solvent or isopropyl alcohol to remove grease and grit, then dry completely before applying lubricant and fitting the shaft.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved