Serpent SER401856 1.2mm X20 Antirollbar Precision Setup  [SER401856]

Serpent SER401856 Antirollbar 1,2mm X20
Price:
NZD$8.95
Brand:
Serpent
Model:
SER401856
Condition:
Brand New
Write a review

Improve Corner Control on X20

The Serpent SER401856 antirollbar is crafted to sharpen the Medius X20 MID 1/10 EP RC car's balance through corners. Its 1.2mm profile helps the car stay planted, making steering feel more predictable at racing pace.

Suitable Models and Conditions

This part is intended for Medius X20 series cars and works with related components like SER400033 and SER400034. It performs best on sealed track surfaces where limiting roll boosts consistency lap after lap.

Quick Installation Advice

Installation is straightforward and needs only common tools. Confirm the bar moves freely in its holders and tighten fasteners to avoid slop; a short test run will reveal any final adjustments required.

Can I use this on both front and rear?

Yes, the design allows use as a front or rear antirollbar where the Medius X20 geometry accepts a 1.2mm bar. Check your setup notes to match handling goals.

Will it work on low-grip surfaces?

On low-grip or loose surfaces a softer bar is often preferable. The 1.2mm bar gives more stability but can reduce mechanical grip if traction is limited.

Any setup tips for tighter corners?

Try pairing the 1.2mm bar with slightly softer springs or more rear toe to balance rotation. Small incremental changes will help find the best feeling without overcompensating.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved