Serpent SER401858 1.4mm Antirollbar for Medius X20 Precision Bar  [SER401858]

Serpent SER401858 Antirollbar 1,4mm X20
Price:
NZD$8.95
Brand:
Serpent
Model:
SER401858
Condition:
Brand New
Write a review

Refine Medius X20 Handling with the Serpent SER401858

The Serpent SER401858 1.4mm antirollbar is a precise upgrade for the Medius X20 family. It reduces excessive roll on flat tracks so tyres maintain contact and steering remains consistent through sweeping bends.

Compatibility Notes and How to Fit

Made to suit the Medius X20 MID 1/10 EP variants (SER400033 and SER400034), this antirollbar installs without altering core suspension geometry. It is a simple swap for tuners wanting finer roll control.

Advantages of the 1.4mm Option

At 1.4mm this bar offers a middle ground between soft and rigid settings, providing more lateral support while still letting the chassis absorb minor surface imperfections.

Can I use this on road and carpet surfaces?

Yes, the 1.4mm bar is well suited to smooth surfaces like asphalt or carpet, where reduced roll improves lap-to-lap consistency.

Does it require different shocks?

You may find benefit in tuning shock oil or spring rates after fitting to rebalance roll and rebound characteristics for your setup.

Will it change corner entry behaviour?

A stiffer antirollbar tends to tighten corner entry and can shift balance; test on a few runs to see if further front or rear adjustments are needed.

Is any trimming required to fit?

If you are installing on the intended Medius X20 models no trimming is usually needed, but always inspect clearances around steering linkages.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved