Serpent SER401867 Rear Centre Carbon Stiffener for X20  [SER401867]

Serpent SER401867 Chassis stiffner center Rear carbon X20
Price:
NZD$19.39
Brand:
Serpent
Model:
SER401867
Condition:
Brand New
Write a review

Serpent SER401867 Rear Brace for the X20

The Serpent SER401867 rear chassis stiffener is a carbon upgrade tailored for the Medius X20 MID 1/10 EP. It enhances the structural strength of the rear chassis to help keep the car steady through fast sections.

Benefits for X20 Rear End

Designed specifically for the Medius X20 series, this carbon stiffener offers an accurate fit for X20 MID 1/10 EP models. Reinforcing the rear reduces deflection and helps maintain predictable handling across different track surfaces.

Quick Fit and Compatibility

Installation is simple and suitable for hobbyists at all levels. The stiffener mounts to the existing chassis points and provides added rigidity without noticeably increasing mass.

Is the Serpent SER401867 compatible with tuned X20 kits?

It is made for the standard Medius X20 MID 1/10 EP chassis. If your kit has non standard holes or modified rear mounts you should compare fitment before purchase.

Will I need extra screws or spacers?

Most installs use the original hardware. Keep basic RC hand tools handy; extra spacers are rarely necessary unless your setup is altered.

Does it add weight to the rear?

Carbon provides stiffness with minimal weight. You will get a noticeable rigidity boost without a significant increase in rear mass.

Can I run it on carpet and asphalt?

Yes, the added rear stiffness helps stability on a range of surfaces, though you may fine tune suspension to suit each surface.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved