Serpent SER401870 X20 MID Centre Chassis Brace  [SER401870]

Serpent SER401870 Chassis stiffner center mount mid X20
Price:
NZD$26.94
Brand:
Serpent
Model:
SER401870
Condition:
Brand New
Write a review

Mid-chassis brace overview for Serpent SER401870

The Serpent SER401870 acts as a centre chassis brace for the Medius X20 MID 1/10 EP model, improving structural integrity where the chassis tends to flex. It is intended to deliver a cleaner, more repeatable handling platform for practice and race sessions.

Supported X20 models and fitting notes

This stiffener matches the Serpent Medius X20 Series and is compatible with the X20 MID 1/10 EP variants (SER400033 and SER400034). The part aligns with the existing mounting points so you can install it without cutting or heavy modification.

Why add central stiffness

Using the SER401870 reduces centre chassis movement during aggressive cornering, which can translate to smoother turn-in and steadier throttle response out of bends for drivers chasing consistency.

Does the SER401870 require chassis trimming to fit?

No trimming is normally required; the stiffener uses the Medius X20 MID factory mounting locations so it sits into place with standard assembly steps.

Will the stiffener noticeably add weight?

Any weight change is minimal compared with the handling benefits; the focus of this part is stiffness rather than mass.

Is the part ready for direct mounting?

Yes, it is manufactured to match the chassis mounting holes on the X20 MID so it installs with the standard hardware supplied for the kit.

Should I change my shock settings after fitting?

Often a small tune of rebound or spring rate helps optimise the new stiffness level; test adjustments on familiar track sections to find the best setup.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved