Serpent SER401871 Shocktower Reinforcement Kit for X20  [SER401871]

Serpent SER401871 Shocktower stiffner set Front/Rear X20
Price:
NZD$44.48
Brand:
Serpent
Model:
SER401871
Condition:
Brand New
Write a review

Lock in X20 Chassis Feel with Shocktower Reinforcers

Give your Serpent Medius X20 MID 1/10 EP crisper handling by installing the Serpent SER401871 shocktower stiffener set. This front and rear reinforcement helps the chassis track truer under load and improves driver confidence through quick direction changes.

How Stiffeners Affect Handling

By bracing the shock towers, the stiffeners limit movement where the shocks mount, which translates to steadier damper performance. The result is reduced mid-corner squat and more consistent rebound behaviour, making setup adjustments more predictable.

Quick Fit Guide

Fitting the parts is a simple workshop job. Remove the shock assemblies, place the stiffener plates, then refit and evenly tighten the hardware. Check mounting screws after a few laps and during regular maintenance sessions.

Will these stiffeners work with alternative shock mounts?

These are tailored for the stock Serpent Medius X20 MID tower layout. If you run aftermarket towers, compare hole spacing and fit before purchase.

Should I change spring rates after fitting?

You may find a slight preference for firmer springs to match the reduced flex, but small incremental changes are advised to tune balance without overcompensating.

Do the stiffeners affect ride height?

They do not directly change ride height, but stiffer towers can alter dynamic suspension behaviour, so check corner weights and ride height after fitting.

How often should I recheck the hardware?

Inspect fasteners after the first run and then as part of regular maintenance. Racing conditions may require more frequent checks.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved