Serpent SER401873 X20 Rear Brace - Chassis Reinforcement  [SER401873]

Serpent SER401873 Chassis brace set Rear X20
Price:
NZD$48.50
Brand:
Serpent
Model:
SER401873
Condition:
Brand New
Write a review

Serpent SER401873 Rear Chassis Brace for the Medius X20 MID

The Serpent SER401873 rear chassis brace set is built to reinforce the rear end of the Medius X20 MID 1/10 EP platform. It is intended to improve chassis stiffness for more reliable handling when pushing the car hard.

Improved Control on Cornering

Reducing flex in the rear helps preserve suspension geometry under load, giving more consistent traction and control through cornering. The brace is a practical upgrade for club racers and weekend drivers alike.

Compatibility Details and Fit Guide

This brace fits the Medius X20 MID 1/10 EP variants (SER400033) and (SER400034). Installation is straightforward and uses standard mounting points, so you can swap it into your car without cutting or drilling.

Can I install this on a converted touring chassis?

Only if the converted chassis matches the Medius X20 MID rear mount pattern. Confirm the hole spacing before buying to avoid fitment issues.

Will the brace add weight to the rear?

There is a modest weight increase, but the handling gains from reduced flex usually outweigh the slight mass change for track use.

Is any trimming of the body needed after fitting?

Most installations do not require body trimming, but confirm clearance around the rear mounts and make small adjustments if necessary.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved