Serpent SER401874 Rear Chassis Brace for Medius X20  [SER401874]

Serpent SER401874 Chassis center stiffner set Rear X20
Price:
NZD$41.61
Brand:
Serpent
Model:
SER401874
Condition:
Brand New
Write a review

Improve Rear Rigidity with a Simple Upgrade

The Serpent SER401874 Chassis Center Stiffener Set strengthens the rear area of the Medius X20 to limit flex and stabilise the car. Focusing on the back section, it helps maintain chassis geometry under load for more reliable handling.

Benefits on Track

Reducing unwanted flex gives clearer feedback through the steering and helps the car hold a chosen line. That makes setup changes more obvious and easier to dial in at race meetings or club nights.

Compatibility Notes

This stiffener is compatible with Serpent Medius X20 MID 1/10 EP variants SER400033 and SER400034. It is aimed at hobbyists and racers who demand consistent behaviour from session to session.

How difficult is the install on a stock car?

Installation is straightforward for someone familiar with basic RC maintenance; the stiffener uses existing points and only requires hand tools.

Will this change my tuning approach?

Yes, with a firmer rear you may adjust spring rates and anti-roll balance slightly to preserve desired traction and turn characteristics.

Is it suitable for rough outdoor tracks?

The added stiffness helps control chassis movement on uneven surfaces, improving composure over bumps and transitions.

Can I run it with aftermarket carbon parts?

It works alongside many aftermarket components, but check clearances and mounting layouts when mixing brands to ensure a correct fit.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved