Serpent SER401880 X20FWD Performance Aluminium Plate  [SER401880]

Serpent SER401880 Chassis Aluminium X20FWD
Price:
NZD$197.33
Brand:
Serpent
Model:
SER401880
Condition:
Brand New
Write a review

Precision Aluminium Plate for X20FWD

The Serpent SER401880 Aluminium Chassis is tailored for the Medius X20 FWD range, offering a tougher, straighter foundation for your 1/10 EP car. Machined aluminium improves torsional strength and gives a consistent baseline for setup work.

Improved Balance and Handling

By shifting mass distribution and lowering the centre of gravity, this chassis helps the X20FWD hold lines better through bends and respond more predictably to throttle inputs. Drivers will notice tighter entry and steadier exits.

Compatibility Notes and Installation Tips

The SER401880 is compatible with X20 FWD references SER400035 and SER400036. Swapping the stock chassis for this aluminium plate is a simple process for most hobbyists; verify screw lengths and clearances during install.

Can I use this chassis on both stock and tuned cars?

Yes, the SER401880 works with stock setups as well as tuned configurations; the stiffness simply gives a firmer platform to tune from.

Will aluminium add too much weight?

Aluminium is heavier than some composite options, but the trade off is improved rigidity and consistent handling; weight distribution adjustments in setup can compensate where needed.

Are there any known clearance issues to watch for?

Check battery and servo positions after fitting, as the stiffer plate can alter component alignment slightly; a quick test fit before full assembly avoids surprises.

Does the SER401880 require different maintenance?

Aluminium needs routine inspection for burrs and mounting screws; tighten hardware to spec and check for small cracks after heavy use.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved