Serpent SER401926 X20 '21 Race Mount  [SER401926]

Serpent SER401926 Motormount X20 \'21
Price:
NZD$91.45
Brand:
Serpent
Model:
SER401926
Condition:
Brand New
Write a review

Fit the Serpent SER401926 to Your X20 '21 Chassis

Built for the Medius X20 '21 MID 1/10 EP range, the Serpent SER401926 motormount delivers a rigid base for the motor to help keep the drivetrain steady. The accurate machining supports consistent setup from one run to the next.

How It Helps Performance

By limiting motor movement and improving alignment, the SER401926 lowers vibration and drivetrain lash that can upset handling. The result is crisper throttle response and more dependable corner exits.

Quick Installation Notes

Installers should tighten all mounting screws evenly and recheck the spur and pinion engagement after fitting. The mount is straightforward to install on X20 '21 models and can be tuned by slight screw adjustments for best results.

Is special hardware needed to fit this mount?

The mount uses the standard mounting points on the Medius X20 '21. In most cases you can reuse original screws, but inspect fasteners for wear and replace if necessary.

Will this improve lap times?

Improvements come from better consistency rather than outright speed. Reduced vibration and secure mounting can help drivers extract more consistent lap times.

Does it affect weight distribution?

The motormount is a low-mass upgrade and has minimal effect on overall balance. Any change can usually be compensated with small trim adjustments.

Should I check anything after a few runs?

After break-in runs, recheck screw torque and gear mesh. Inspect for any signs of loosening or wear and retighten as needed.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved