Serpent SER401930 0.5mm Suspension Spacer - Race Tuning  [SER401930]

Serpent SER401930 Suspension spacer 0,5mm
Price:
NZD$29.35
Brand:
Serpent
Model:
SER401930
Condition:
Brand New
Write a review

Dial in Medius X20 with a 0.5mm Spacer

When you are dialling setup on a Serpent Medius X20, the SER401930 0.5mm suspension spacer is a handy part for accurate spacing. It matches the Medius X20 '21 MID 1/10 EP platform so your car retains consistent handling under load.

Adjust Ride Feel with Precision

Using this 0.5mm shim lets modelers tweak suspension stiffness and ride height in small steps. Those fine adjustments can improve turn-in and mid-corner balance for both club racing and practice sessions.

Compatibility with Medius X20 Variants

Made for Medius X20 use, the spacer works with SER400037 and SER400038 components. It is an effective choice for pilots wanting targeted setup changes without swapping major parts.

Is this spacer suitable for both front and rear suspension?

Yes, it can be used on either end depending on the setup goals, but adjust symmetrically where needed to keep balance.

Will it affect shock damping feel?

The spacer changes geometry rather than damping directly, but the altered geometry can influence how the shock feels during compression.

Should I recheck camber and toe after fitting?

Yes, small spacing changes can shift alignment slightly, so verify camber and toe after installation to maintain predictable handling.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved