Serpent 411027 Cross Brace Tube Set - Precision Chassis Upgrade  [SER411027]

Serpent SER411027 Cross Brace Tube set Left + Right
Price:
NZD$20.20
Brand:
Serpent
Model:
SER411027
Condition:
Brand New
Write a review

Get Tighter Handling with the Serpent 411027

The Serpent 411027 Cross Brace Tube Set is engineered to add structural support to your model. Including left and right tubes, the set balances frame loads and helps preserve suspension geometry under load. Built from quality materials, these tubes are intended to give long service life and steadier handling for competitive or club use.

Why This Brace Set Helps Your Setup

  • Compatibility: Works with a range of chassis configurations for flexible use.
  • Material Quality: Produced from resilient materials to resist fatigue and impact.
  • Functionality: Reduces unwanted chassis twist to improve turn-in and mid-corner balance.
Measure the brace mounting points on your chassis and compare them to the tube spacing. Trial fitting without permanent fasteners helps verify alignment before final installation.
The tubes add stiffness rather than change suspension pick-up points, so ride height should remain the same while handling becomes more consistent.
Individual tubes can be sourced from parts suppliers if needed; keep part numbers handy to order correct left or right components.
With reduced flex you may find small adjustments to shock tuning or anti-roll settings help exploit the added stiffness for better balance.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved