Serpent 411161 1.5x10mm Roll Pin Set - Precision Fixings  [SER411161]

Serpent SER411161 Roll pin 1.5x10mm (10)
Price:
NZD$13.81
Brand:
Serpent
Model:
SER411161
Condition:
Brand New
Write a review

Precision steel pins for tidy RC fitment

The Serpent 411161 kit contains 1.5x10mm roll pins produced to consistent dimensions so parts stay aligned race after race. These steel pins are suited to securing shafts, linkages and small gear assemblies on common RC platforms.

Designed for steady performance

Built to remain round and true under load, the pins reduce play and help maintain drivetrain integrity. Their length and diameter strike a balance between ease of installation and holding power in tapped or plain bores.

Practical advice for installation

Before fitting, deburr and clean the hole to avoid misalignment. Drive the pin straight with light taps, and check for any wear on mating parts so the Serpent pins deliver reliable clamping without premature loosening.

Do these pins suit gearboxes and driveshafts?

Yes, when the gearbox or shaft specifies a 1.5x10mm pin. They are commonly used in drive assemblies and small gearbox linkages across many models.

Can I re-use these pins after removal?

Re-using is possible if the pin remains straight and undamaged. Inspect closely for mushrooming or deformation and replace if there is any sign of wear.

What tool works best to seat them?

A small pin punch and a light hammer give the best control. Hold the part steady and drive the pin evenly to prevent bending or misalignment.

Should I lubricate the pin when fitting?

A thin coat of oil can ease installation but avoid excess which may attract grit. Clean the area first so the pin seats against clean metal surfaces.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved