Serpent 411195 - S120L Aluminium Right Motor Mount  [SER411195]

Serpent SER411195 Motor pod Right Aluminium S120L
Price:
NZD$48.75
Brand:
Serpent
Model:
SER411195
Condition:
Brand New
Write a review

Precision Aluminium Pod for the Serpent S120L

Built from CNC-machined aluminium, the Serpent 411195 - S120L Aluminium Right Motor Pod is aimed at racers wanting a tidy, reliable motor mounting solution. The material choice supports better heat spread and a firmer mounting point compared with stock parts.

Why Run an Aluminium Motor Pod?

Aluminium increases structural stability without adding unnecessary mass, helping the motor remain secure under acceleration and braking. That translates to steadier power delivery and reduced chances of mounting deformation after repeated use.

Exact Fitment to S120L Geometry

This right-side pod is profiled to match the S120L chassis layout, offering consistent motor position and reduced vibration. Upgrading to this pod simplifies setup tweaks and can make the car more predictable through corners.

Can I use this on a different chassis?

This component is dimensioned for the S120L. While some hobbyists adapt parts between models, expect to verify clearances and mounting points before fitting it elsewhere.

Is aluminium better than composite for durability?

Aluminium tends to resist wear and bending better than many composites under race forces, but it can transfer more shock to nearby components, so check surrounding mounts and bearings.

What hardware should I use?

Use the specified screw sizes and hardened washers where recommended. Apply medium-strength threadlocker to steel fasteners and recheck torque after a few runs.

Will this improve lap times?

An aluminium pod can improve consistency and reduce vibration, which may help lap times when combined with proper setup and electronics calibration.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved